46 found, showing page 3 of 4
$10.99
3/8" I/M MALE PLUG
Industrial Milton design coupler plug. This plug design is considered the industrial standard. Can be identified by the 3/16 In. pilot and flat bottom V-shaped ball groove. Conforms to ANSI (NFPA) T3.20.14-1990 dimensions. Conforms to ANSI (NFPA) T3.20.14-1990 dimensions.
View Details
$10.869
3/8" I/M FEMALE PLUG
Industrial Milton design coupler plug. This plug design is considered the industrial standard. Can be identified by the 3/16 In. pilot and flat bottom V-shaped ball groove. Conforms to ANSI (NFPA) T3.20.14-1990 dimensions. Conforms to ANSI (NFPA) T3.20.14-1990 dimensions.
View Details
$53.99
3/8"I/M FEMALE COUPLER
Air line coupler features 100\% air-tight seal, accidental disconnect protection, and tubular valve construction which promotes greater air flow.
View Details
$35.49
ADJUSTABLE BLOWGUN
Twist to adjust from partial to full volume air flow. Recommended air pressure to 150 P.S.I. maximum. Knurled nozzle. Pocket clip. Industrial/Milton design. Fits all Milton design 1/4" coupler bodies. 1 per card.
View Details
$15.512
BICYCLE TIRE PATCH KIT
Repairs all tube and bias bicycle tires. Pure rubber flows into the injury. May be applied with universal cement or an electric vulcanizer. Contains 6 assorted patches, cement, and a thumb buffer. Chembond patches. Camel brand. Carded.
View Details
$260.99
MINI FILTER REGULATOR
Gives accurate pressure regulation with maximum water and dirt separation. Increases life of expensive air-powered tools. Solid piston resists rupture, cracking, or tearing under pressure or high cycle rates. Maximum operating pressures: 150 P.S.I. at 125 deg. F. primary, 2 to 125 P.S.I. secondary. Operating temperature range: -10 deg. F. to +175 deg. F. Includes filter element and a pressure gauge. Port size: 1/4" NPTF. Manual drain. 5 micron element. Bowl capacity - 1 oz. Overall height: 8-1/2". 1 per box.
View Details
$6.29
1/4" ARO MALE PLUG
Tru-Flates ARO design coupler plug. Similar appearance compared to the industrial interchange.
View Details
$9.382
1/4" LINC MALE PLUG
Lincoln design coupler plug.
View Details
$22.909
1/4"T-F FEMALE COUPLER
Air line coupler features 100\% air-tight seal, accidental disconnect protection, and tubular valve construction which promotes greater air flow.
View Details
$29.99
1/4" ARO FEMALE COUPLER
Air line coupler features 100\% air-tight seal, accidental disconnect protection, and tubular valve construction which promotes greater air flow.
View Details
$52.49
1/4" FEMALE COUPLER
Air line coupler features 100\% air-tight seal, accidental disconnect protection, and tubular valve construction which promotes greater air flow.
View Details
$14.904
TIRE CHUCK
Use when air supply lines come directly from the compressor with no other valve in the line. Comes with a built-in shut-off valve and therefore cannot be used on inflator gauges. Combination 1/4" Female NPT chuck with 1/4" I.D. hose barb. 150 P.S.I. maximum air line pressure.
View Details
$28.99
DUAL FOOT CHUCK
1/4" Female NPT. Standard dual foot extension for valves on tractors, trucks or buses. 150 P.S.I. maximum air line pressure.
View Details
$7.458
MALE COUPLING
Thread size: 1/4" Male NPT x 1/4" Male NPT. Brass. 1 per card.
View Details
$43.99
STANDARD BLOWGUN
Oil-resistant, soft replaceable rubber tip. Will not mar delicate surfaces. Gives a leakproof seal against oil passages, fuel lines, etc. when air pressure is needed for cleaning. 1/4" Female NPT inlet. Allows full line pressure to be used. To comply with OSHA regulations this blowgun must be used on a regulated air line with a pressure setting not to exceed 30 P.S.I.
View Details